Remote Control Explanation - Conceptronic CM2H Manual De Usuario

ENGLISH
The remote control is used to control the CM2H. On the inside cover of this manual you will find a picture
of the remote control. The numbers of the buttons correspond with the table below, to explain each
function of the remote control.
Nr Button
1 POWER ( )
2 SETUP
3 R / L
4 SLIDE
5 SLOW
6 A – B
7 REPEAT
8 VOLUME
9 VOLUME
10 MUTE
11 REWIND ( )
12 FAST FORWARD (
13 PLAY/PAUSE
14 BACK
15 , , ,
16 AUDIO
17 DIR
18 MENU
19 FILE
20 MUSIC
21 PHOTO
22 VIDEO
23 OTB
24 FUNC
25 SUB-T
26 ENTER ( )
27 TOP
28 STOP ( )
29 PREVIOUS ( )
30 NEXT ( )
31 INFO
32 PAGE
33 PAGE
34 ROTATE
35 DELAY
36 ZOOM
37 TRANS
38 P / N
39 OUTPUT
40 Power LED
22

5. Remote control explanation

Description
Switch between Media Player Mode or Standby Mode
Open the Setup menu.
Change the audio output (Stereo, Mono-L, Mono-R).
Start a Music-slide-show mode or start video step-play.
Play back slowly.
Play a selected interval repeatedly.
Select a repeat / shuffle mode.
Increase the volume.
Decrease the volume.
Mute or cancel mute.
Fast Rewind during playback.
) Fast forward during playback.
Start the playback of a file or DVD-Folder or pause a playback.
Back to the previous folder.
Move the selection in the main menu or DVD menu.
Select or change the audio stream (DVD Playback).
Select a target folder for the manual copy function.
A. Show the „Partition/Device List‟ or „File List‟
B. Return to the DVD Menu (DVD Playback).
Show the „File Library‟.
Direct access button to the „MUSIC‟ folder.
Direct access button to the „PHOTO‟ folder.
Direct access button to the „VIDEO‟ folder.
Initiate the OTB copy function.
Open the functions menu in the file browser.
Select or change movie Subtitle (MPEG4 & DVD Playback).
Confirm selection or start playback.
Go to the top of the current file list.
Stop playback.
Switch to previous file or chapter.
Switch to next file or chapter.
Show playback information during playback.
Show the next page with files.
Show the previous page with files.
Rotate photos.
Select the slide show (include music-slide-show) interval time.
Zoom in or out (Photos & DVD Playback).
Select a mode of transition during a slideshow or a type of music
equalizer during music playback.
Select a video system. (PAL / NTSC)
Select the Video Output Signal.
The Power LED will blink when a button is pressed.