Basic Device Operation - Conceptronic CM2H Manual De Usuario

 Select the correct input channel on your TV where the CM2H is connected to. (HDMI, Composite or
SCART).
Note: From this point, the manual is based on the fact that your TV is set to the input channel of the
CM2H. All steps described are related to the operation of the CM2H.
 If the CM2H is not yet turned on, you can turn on the CM2H with the „Power‟ button [M]on the top of
the CM2H, or with the „Power‟ button (1) on the remote control.
The CM2H will turn on and display the menu on your screen.
Note: The CM2H will detect the output signal automatically. If the CM2H is turned on and nothing is
shown on your screen, you can press the „Output‟ button (39) on the remote control to switch
between the various outputs of the CM2H (HDMI and AV output).
Note: The CM2H needs to initialize the hard disk when it is turned on. During initializing, the message
„LOADING...‟ is shown on your screen.
When the hard disk is formatted with 1 partition, it will show the „File List‟ on your screen, displaying
the contents of your hard disk.
When the hard disk is formatted with multiple partitions, the CM2H will show the „Partition/Device List‟
on your screen with all the present partitions. Use
„ /Enter‟ (26) button to go to the „File List‟, showing the contents of the selected partition.
[ Partition/Device List ]
Change the partition:
When the hard disk is formatted with multiple partitions, you can press the „Menu‟ (18) button on the
remote control to go to back to the „Partition/Device List‟ and select a different partition.

7. Basic device operation

/ buttons (15) to move the selection, and press the
ENGLISH
[ File List ]
25