Getting Started; Turning The Unit On And Off; Setting The Time; Setting The Source Mode - Naxa NHS-7008 Manual De Operación

Getting Started

Turning the Unit On and Off

To turn the unit on, press the
screen [2] will light up.
To place the unit in Standby mode, press the
ton on the remote until the display screen [2] shows the
time.
To turn the unit off completely, disconnect the unit
from power.

Setting the Time

The time is shown on the display screen [2] when the
unit is in Standby mode. To set the time:
1. Press and hold the CLOCK button on re-
mote control. The hour digit will blink.
2. Press the TUN- or TUN+ button [4, 5] to adjust the
hour while it is blinking. Press CLOCK to
save the hour; the minutes will blink.
Page 12
button [8]. The display
but-
3. Press the TUN- or TUN+ button [4, 5] to adjust the
minutes while it is blinking. Press CLOCK to
save the minutes. The time is now set.

Setting the Source Mode

Press MODE [8] to set the active source mode. This
controls which connection is being used.
The display screen [2] will indicate which mode has
been selected when MODE [8] is pressed.
Display Screen
FM FM radio
BT Bluetooth
USB USB [13]
CARD SD/SDHC card reader [14]
OPTI Optical audio input [12]
AUX1 3.5mm audio input [9]
AUX2 RCA stereo input [11]
Connection Mode
®
Naxa Electronics