Naxa NHS-7008 Manual De Operación página 5

Naxa Electronics recommends that wall mounting be
performed by a qualified professional installer. Naxa
is not liable for any accidents or damage to property
or the sound bar due to incorrect installation.
1. Using a level and ruler, use a pencil to mark 2 points
on the wall that are 33.4 inches apart. Use the level
to ensure that the points are on the same horizon-
tal plane.
1. Screws
2. Wall bracket
3. Drywall plugs
(optional)
www.naxa.com
3
2
1
2. Use the wall brackets as a template to mark a sec-
ond set of points on the wall. Make sure the bracket
is level before marking the wall, and that the points
are level with each other.
3. Use the drill to drill a hole at each of the 4 marked
points on the wall. Select a drill bit that is appropriate
for your wall's construction. If you are using the dry-
wall plugs as directed in step 4, make sure the diam-
eter of the drill bit matches the diameter of the plugs.
4. For drywall installations only; for wood, skip to
step 5: using a hammer, gently insert the drywall
plugs in each of the holes. The plugs should fit
completely into the hole, with the tops of the plug
flush with the wall.
(For installations in brick or concrete walls, please
obtain masonry plugs from your local hardware
store.)
5. Use a screwdriver and two screws to affix the left
bracket to the wall, then do the same for the right
bracket. Hand-tighten the screws; do not over-
tighten them! Note the orientation of the hooks
on the bracket in the illustration.
Page 5