Tabla de contenido
Publicidad
Chapter 2
|
Operation
2-4
|
Isotemp
General Purpose Water Bath Specifications
Reservoir Fluid Control
Temperature °C
°F
Set Point Temperature
Range°C
°F
Ambient Temperature °C
Range °F
Stability @ 37°C
Uniformity @ 37°C
Heating Output watts
Bath Volume liters
Overall Bath Dimensions
(L x W x H) cm
inches
Bath Work Area
Dimensions
(L x W x H) cm
inches
Approximate Weight kg
lb
Electrical
Requirements (VAC/Hz)
(Voltage ±10%)
Compliance
Maximum Relative
Humidity
(Non Condensing)
Operating Altitude meters
feet
Overvoltage Category
Pollution Degree
Storage Temperature °C
Range °F
Low-end temperatures require supplemental cooling.
Specifications obtained at sea level using water.
Thermal beads may be used instead of water but they will degrade the bath's uniformity and stability.
Bath depth includes bezel, height does not include lid.
Fisher Scientific takes no responsibility for damages caused by the selection of an unapproved fluids.
Fisher Scientific reserves the right to change specifications without notice.
GPD 20
Ambient to 100
Ambient to 212
1200
20
39.2 x 55.5 x 23.3
39.2 x 55.5 x 28.2
15.4 x 21.8 x 9.2
15.4 x 21.8 x 11.1
29.7 x 50.0 x 15.0
29.7 x 50.0 x 20.0
11.7 x 19.7 x 5.9
11.7 x 19.7 x 7.9
10
22
100-115/50-60
200-230/50-60
CE
UL
80% for temperatures up to 31°(88°F)
decreasing linearly to 50% relative humidity at 40°C (104°F)
Sea Level to 2000
Sea Level to 6560
-13 to +140
GPD 28
GPD 15D
+5 to 100
+9 to 212
+15 to 45
+59 to 113
±0.1
±0.2
1200
300 and 800
28
5 and 10
39.2 x 58.7 x 23.3
15.4 x 23.1 x 9.2
See GPD 05 and GPD 10
12
26
or
RoHS
WEEE
II
2
-25 to +60
TBD
TBD
Fisher Scientific
Publicidad
Tabla de contenido
