Tabla de contenido
Publicidad
Fisher Scientific
Temperature Display
28.1°C
Shut Down
•
Press
to stop the bath heating and, if applicable, shaking.
Note Pressing and holding
controller display. Press
•
For bath shut down place the circuit protector located on the rear of the bath to the O position.
•
To disconnect the bath remove the electrical plug from its power source.
With the bath running, and after 30 seconds, if
none of the keys are pressed, the controller will
display only the reservoir fluid temperature and
any active feature. Press any key to return to the
previously displayed screen.
for three seconds stops the heating and powers down the
to turn the display back on.
Chapter 4
Operation
|
4-7
Isotemp
|
Publicidad
Tabla de contenido
