Start Up - Fisher Scientific Isotemp Manual Del Usuario

Chapter 4
| Operation
CAUTION
CAUTION
4-2
| Isotemp

Start Up

Before starting, double check all electrical connections.
An operating shaking water bath has moving components. Do not insert appendages
between the reservoir wall and rack. We recommend stopping the shaker table when
loading/removing samples or vessels.
For shaking water baths, ensure all glass vessels are secure. Unrestrained vessels
may shift and break when shaking is engaged. Flask clips and trays are available from
Fisher Scientific.
Do not run the bath until fluid is added to the reservoir. Have extra fluid on hand. If the bath does
not start refer to Chapter 6 Troubleshooting.
Place the circuit protector located on the rear of the bath to the I position.
•
• The screen will momentarily display
the set point and the audible alarm status. The set point is the desired reservoir fluid temperature.
• Press to start the bath and display the reservoir fluid temperature. If the fluid
temperature is below the set point the heater will start.
29.9°C
30.0°C
appears on Shaking Water Baths only.
and then the home screen appears displaying
30.0°C
Fisher Scientific