Changing A Setting - Fisher Scientific Isotemp Manual Del Usuario

Chapter 4
| Operation
4-4
| Isotemp

Changing a Setting

Press the soft key below
O I
This icon represents the timer. It is used to set the amount of time required, in hours and minutes, before the
bath turns off. When the bath turns off the alarm, if enabled, will beep.
O I
00:00
O I
These icons represent the audible alarm status. The top indicates it is enabled, the bottom
indicates disabled. Press
highlight another setting or press
This icon represents the high temperature alarm. If the reservoir fluid exceeds this temperature
the bath will shut down and, if enabled, the alarm will sound. The controller will also have an error
display, . See Chapter 6.
95. °C
to display the Setting screen.
CAL
Use the arrow keys to highlight the desired setting. Press
°C
°C
!
Press, and hold, the arrow keys to change the time.
Once the desired value is displayed press
to save the change or
zero. Press
x
Note You can only set an off time if the bath is
running.
to toggle between enabled/disabled. Use the arrow keys to
to return to the home screen.
Press, and hold, an arrow key to change the
temperature. Once the desired value is displayed
press
0
not save the change.
x
Press
appears on GPD Baths only.
to make changes.
x
to reset the time to
to return to the home screen.
to save the change or
to return to the home screen.
x
to
Fisher Scientific