Tabla de contenido
Publicidad
CAUTION
CAUTION
Fisher Scientific
Draining
Drain the bath before moving or storing.
Ensure the fluid is at a safe handling temperature, ~40°C or lower. Wear protective
clothing and gloves.
•
Place a suitable receptacle underneath the drain.
•
Slowly turn the drain plug until flow is observed.
•
When the flow stops close the drain plug.
Draining
(GPD 10, GPD 20, GPD 28 and GPD 15D only)
•
Remove the drain hose from its
housing and insert the fitting into the
drain quick disconnect.
•
When the flow stops remove the
hose and reinsert it back into the
housing.
Accessories
Only use the accessories supplied by Fisher Scientific.
Drain Kit Accessory
•
Before filling the bath remove the
drain plug from the bath drain.
•
Wrap coupler with Teflon
®
equivalent, and install into bath drain.
•
Insert quick disconnect into hose.
•
To start draining snap quick
disconnect onto coupler.
•
To remove quick disconnect from
coupler and stop draining press
down on the disconnect's grey
release.
Figure 3-3 – GPD Bath Drain Hose
tape, or
Figure 3-4 – Drain Kit Accessory
Installation
Coupler
Quick Disconnect
Neoprene Hose (3/8ID x 5/8OD)
Isotemp
Chapter 3
|
3-7
|
Publicidad
Tabla de contenido
