Operating The Unit - Allmand PAL50 Dual Manual Del Operador

Work Surface
The portable work light must be placed on a firm, stable
surface capable of supporting the total weight of the work
light. The surface should be level, and must not exceed a
grade of 5% (2.8° incline) in any direction.
WARNING
Rollover / Tipover Hazard.
Positioning the portable work light on soft or unstable
ground could cause work light rollover resulting in death or
serious injury. Always position the work light on a firm, level
and stable surface.

Operating The Unit

To Operate The Unit
1. Connect the LED fixtures.
Loosen the cable tie. Connect the base cables to the
fixture cables.
2. Position the LED fixtures.
8
The LED fixtures may be rotated left / right, and up /
down.
3. Raise the mast to the desired height.
Turn the winch handle clockwise to raise the inner mast
to the desired height.
4. Connect the power cord and turn on the work light.
1. Connect the power cord to an outlet on a wall or
power generator.
Note: If an extension cord is required, use an extension
cord rated for the current required by the work light.
See Specifications for detailed information on power
requirements.
2. Move the power switch(es) to the ON position.
To Shut Down The Unit
1. Shut off the work light and disconnect the power
cord.
1. Move the power switch(es) to the OFF position.