General Maintenance - Allmand PAL50 Dual Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Disconnect the power cord from the outlet on the wall
or power generator.
2. Lower the mast.
Turn the winch handle counterclockwise until the inner
mast is fully lowered.
Maintenance

General Maintenance

WARNING
Shock Hazard.
Contact with high voltage could result in death or serious
injury. Turn off the unit and disconnect the power cord
before you do maintenance.
Burn Hazard.
Contact with hot surfaces could result in death or serious
injury. Wait 10 minutes after turning the unit off before you
do maintenance.
• Make sure that the unit is in good operating condition.
See Preparing the Unit for Use .
• Make sure that no components are missing, worn or
damaged.
WARNING
Do not operate the unit with missing, worn or damaged
components. Death or serious injury could result. Contact
your authorized dealer for service.
• Make sure that all the hardware on the unit is tight.
• Wipe down the unit with a damp cloth to remove dust, dirt
and debris.
• Occasionally apply a small amount of grease to the
wheels.
Location of Serial Number Plate
The serial number plate for the work light is located on the
end of the base near the power switch. 
Location of Weight and Power
Information
 Information on the weight of the work light is located on top
of the base near the mast. 
 Information on the electrical requirements for the work light
is located on top of the base near the mast and next to the
weight decal. 
Troubleshooting
Problem
No light
1. Unit not plugged in. Plug unit into power source.
2. Power switch turned off. Turn power switch to ON.
3. Base cable not connected to fixture cable. Connect base
cable to fixture cable.
4. Unit malfunction. Contact authorized dealer.
Specifications
 Dimensions 
Description 
Overall Length 
Overall Width 
Overall Height (Fully Lowered) 
Overall Height (Fully Extended) 
 Weight 
Description 
Overall 
Base 
Mast 
Light Bar 
Light Fixture (each) 
 Power Requirement 
Description 
Frequency - Hertz 
Volts 
Amps 
Possible Cause
In 
49.4 
41 
90 
138 
Lb 
224 
153 
30 
17 
PAL50
Dual
LED 
50 
220 
Cm 
125.4 
104.1 
228.6 
350.5 
Kg 
101.6 
69.4 
13.6 
3.2 
7.7 
PAL60
Dual
LED 
60 
120 
9

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Pal60 dual

Tabla de contenido