Kohler STERLING 5900 Serie Guia De Instalacion página 9

Bumper
#8-18 x 1-1/2"
Panhead Screw
7. Install the Wall Jambs
Place a wall jamb over the bottom track. Align the holes in the wall jamb with the holes in the wall.
NOTE: The middle screw should be inserted through a bumper before being installed. Do not overtighten
the middle screw or damage to the bumper may occur.
Secure the wall jamb to the wall with three #8-18 x 1-1/2" panhead screws.
Repeat the procedures with the other wall jamb.
Install screw covers over the top and bottom screws in each wall jamb.
8. Install the Top Track
NOTE: The top track is designed so either side may be positioned facing outward according to your
preference.
Measure the distance from wall to wall at the top of the wall jambs.
Mark the top track at the determined dimension.
NOTE: For best results use a 32-teeth per inch hacksaw and miter box.
Cut the top track on the inside edge of the mark [approximately 1/32" (1 mm) from the mark] to
allow space for the top track to slide into place easily.
Carefully file the rough edges smooth where the top track was cut, taking care to avoid damaging
finished surfaces.
Position the top track over the wall jambs and gently push down.
Sterling
Screw
Cover
Top Track
9
Measure here.
1034033-2-B