Non Ducted Recirculation Option - Faber LEVG24SS300 Instrucciones De Instalación

NON DUCTED RECIRCULATION OPTION

a
Required Activated Charcoal
Filter Accessory - (FILTER5)
purchased separately.
Non Ducted installations only:
1. Remove the two screws located on the motor
housing in the location indicated.
2. Place the charcoal filter with the tabs against
the blower housing in the location indicated on
c
figure . The front side of the FILTER5 will
have the keyhole mounting on the top surface
of the filter. A layer of charcoal will be visible
through the grills.
3. Use the two screws removed earlier to attach
the FILTER5 in place.
NOTE: For Non ducted installations the Canadian
Grid should NOT be used.
d
Remove the indicated blower cover
(do not discard the screw).
b3
Reinstall the modified blower cover
with the same screw.
c
Reinstall the existing Grease Filters
after installing the Activated Charcoal
Filter before operating hood.
Cut the
b1
cover
where
indicated in
picture b1.
Discard /
b2
Recycle
upper
pieces of
blower
cover.
Go to page 20
15