Adjusting And Setting The Motor Head Angles - Fanimation Caruso FP7000 Serie Manual Del Propietário

Adjusting and Setting the Motor Head Angles

INSTALLATION NOTE
BOTH MOTOR HEADS MUST BE SET AT THE SAME
ANGLE!
NOTE: This step is applicable after the necessary fan
assembling, hanging and wiring is completed.
CAUTION
To reduce the risk of personal injury or damage to fan
assembly, be sure to support the motor heads when
adjusting or changing angles on the "knee-joint".
1. Remove knee caps from both side of each knee joints by
twisting counter-clockwise. Figure 1 shows the angle tick
mark details on both sides of "knee-joint" on the motor.
NOTE: The single screw (per each motor) serves as the
index stop for each angle setting.
See chart below.
CAUTION
Do NOT Fully Remove The Center
Knee Bolt, Only Loosen.
2. Be sure to secure the screw
as shown per each motor in the
corresponding chart below:
3. After setting corresponding motor
head angles, be sure to securely
tighten the nut on the knee bolt.
(Figure 1)
4. Secure the knee covers on the
knee bolts on both side of each knee
joint. (Figure 2)
Figure 2
NOTE: 22˝ Natural Palm Blades Are
NOT To Be Used At The 60° Setting.
Tighten Nut
After Setting
Angle
Illustration
Setting
0°
Vertical
15°
30°
45°
60°
14
Angle
Figure 1
Side A
of Joint
Tick Mark on 0°
Screw
Tick Mark on 30°
Tick Mark on 60°
Screw
Side B
of Joint
Tick Mark on 15°
Screw
Screw
Tick Mark on 45°
Screw