Installing The Canopy Housing; Assembling The Fan Blades - Fanimation Caruso FP7000 Serie Manual Del Propietário

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

NOTE: This step is applicable after the necessary wiring

is completed. (see pages 8 and 9)

▲WARNING

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the canopy housing

and not pinched between the housing and the ceiling.

1. Screw in two threaded rods into the Hanger Bracket

(Figure 1a).

NOTE: The threaded rods in the hanger bracket serves as

guides for easier installation.

2. Securely attach the Canopy Housing to the Hanger

Bracket using the external lockwashers and knurled knobs

supplied with your fan (Figure 1b)

INSTALLATION NOTE

Do not connect fan blades until the fan is completely

installed. Installing the fan with blades assembled may

result in damage to the fan blades.

▲WARNING

To reduce the risk of personal injury, do not bend the

blade holders when installing, balancing the blades or

cleaning the fan. Do not insert foreign objects in between

the rotating blades.

1. Remove and discard the (rubber) motor "stops" by

removing the five screws. (Figure 1)

Blade & Blade Holder Assembly:

2. Lay the side of the blade holder on a flat surface with the

inside of the blade holder facing up.

3. Assemble the blade to the blade holder with the carriage

nuts, washer-head screws & fiber washers and the blade

cover. Make sure the bottom edge of the blade is fully

seated against the blade holder.

4. Tighten screws with a screwdriver provided, don't over-

tighten. (Figure 2)

5. Attach assembled blades and blade holders to the motor

hub using the provided screws & lock washers. (Figure 3)

6. Make sure the screws securing the blade holders to the

motor hub are tight and that the blade holders are properly

seated.