Battery Charge From A 12V Socket; 6.1 Control Pannel - Ghibli & Wirbel ROLLY 7 1/2 Uso Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 79
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
NOTE:
For the full recharge of the battery, 2 hours
are necessary for the 10 A battery and 4
hours for the 20 A battery.
Partial recharges are also possible.
5.1.a - Battery charge from a 12V
socket (Fig. 4a - 9)
-
Place the machine in the vehicle or van
trunk.
-
Lower the selector (5) in order to release
the battery (6).
-
It is possible to leave the battery in the
machine or to remove it if needed.
-
Insert the plug (27a Fig. 4a) in the battery
(6), then connect it to the battery charger
(35) at a 12V power outlet of the vehicle
or van.
WARNING:
The machine is fitted with a safety device
which prevents its operation with an open
battery compartment.

6.1 CONTROL PANNEL

(Fig. 10)
30) Start-up button
-
If pressed for three seconds it actuates
the circuits; the LED (31) turns on indica-
ting the inserted line, the vacuum cleaner
operation LED (32) turns on, the water
supply LED (33a) turns on and one of the
battery status LED (34) turns on.
NOTE:
Dopo 5 minuti che la macchina è inattiva au-
tomaticamente si spegne ed è necessario
ripremere il pulsante (30) per riavviarla.
36) Water supply button
-
If this button is pressed, the quantity of
water to be supplied during the cycle until
the end of the supply can be set up, by
passing from one quantity to another, the
quantity is indicated by one of the LEDs
(33);
Led 33a = minimum supply.
Led 33b = average supply.
Led 33c = maximum supply.
Leds 33 turned off = no supply.
NOTE:
The rotation of the brush is enabled by the le-
vers (4) pressed or by the lever (3) pressed.
It is possible to cut off the water supply by
pressing the button (36) until all LEDs (33)
are turned off.
37) Vacuum cleaner button.
-
Upon the start-up of the machine, the va-
cuum cleaner is set to standard operation
and the LED (32) turns on.
-
It is possible to go from a normal opera-
tion to a silent operation until the vacuum
cleaner is turned off by pressing the but-
ton (37).
The lit LED (32) indicates a normal ope-
ration.
The lit LED (38) indicates a silent opera-
tion.
The turned off LEDs (32) and (38) indica-
te the turned off vacuum cleaner.
NOTE:
The vacuum cleaner will operate for another
10 seconds before turning off when switched
from silent operation to off.
NOTE:
The operation of the vacuum cleaner is ena-
bled by the levers (4) pressed or by the lever
(3) pressed.
ENGLISH - 7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rolly 11

Tabla de contenido