Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION OF WHEELS
Use of wheels facilitate transportation of the vacuum cleaner. Smaller castors are located in front base
facilitate manoeuvring, large back transport wheels guarantee stability of the vacuum cleaner.
● Release fixing clamps (3) on both sides of the device and remove upper body (7) (fig. A).
●
Turn the container (
6), place support for wheels (10) in the base sockets (11) and fix with screws (fig. B).
●
Install front castors (
5) by pushing them into holes in the support for castors (10) (fig. C).
●
Install rear wheels (
5) by pushing them into holes in the support for wheels (10) (fig. D).
●
Turn the container again and install upper body (
You can transport the vacuum cleaner a work place by rolling on castors with the use of transport handle (1).
INSTALLATION / REPLACEMENT OF PLEATED FILTER
Disconnect the tool from power supply.
●
Release fixing clamps (
●
Place pleated filter (
a) on the float body (b). Ensure it is installed properly (fig. E).
●
Install upper body (
7) and secure with fixing clamps (3).
Replace damaged pleated filter with a new one.
INSTALLATION / REMOVAL OF DUST BAG
Dry cleaning requires dust bag. Using the dust bag prevents clogging of the pleated filter and extends its
lifetime, and facilitates emptying the waste later.
●
Release fixing clamps (
●
Slide the dust bag hole onto connector pipe (
●
Ensure the dust bag adheres to inner wall of the tank in its whole length.
●
Put upper body in place (
●
To remove the dust bag, proceed with above procedure in reverse order.
Check filling of the dust bag regularly. When the dust bag is full, replace it with a new one.
INSTALLATION OF SUCTION HOSE
● Slide the suction hose into the connection socket (4), turn clockwise and gently pull back (fig. G).
●
Connect the other end of the suction hose to telescopic pipe.
●
Deinstallation of the suction hose is similar to installation, only the sequence of actions is reversed.
INSTALLATION OF TELESCOPIC PIPE AND ATTACHMENTS
● Push the suction hose connection to the telescopic pipe holder so the latches snap in place.
●
Move the slider (
g) down and extend the telescopic pipe to desired length (fig. H).
●
Put appropriate attachment onto telescopic pipe.
Floor attachments are especially useful for cleaning large areas and in wet operation mode. Crevice
attachment is suitable for cleaning edges, corners and crevices.
INSTALLATION OF POWER CORD HOOKS
● Push lower hook for power cord (12) into hole in the base (11).
●
Push upper hook for power cord (
SWITCHING ON / SWITCHING OFF
The mains voltage must match the voltage on the label of the vacuum cleaner.
Vacuum cleaner features 3-position switch (8). Depending on the work performed set the switch in
appropriate position (fig. J).
●
Pos I
(upper position of the switch) – device operates like ordinary vacuum cleaner.
PREPARATION FOR OPERATION
3) on both sides of the device and remove upper body (7).
3) on both sides of the device and remove upper body (7).
c) located in the tank (6) (fig. F).
7) and secure with fixing clamps (3).
12) into hole in the upper body (7) (fig. I).
OPERATION / SETTINGS
14
7).
Publicidad
