Troubleshooting
TROUBLESHOOTING
Malfunction
Motor does not run
No chain lubrication
In the case of faults that are not listed in this table, or faults that you cannot rectify without
assistance, please contact our customer service department.
440105_e
Possible cause
No mains power
Motor protection switch has swit-
ched off
Chain brake tripped
Oil tank empty
Chain bar contaminated
Solution
Check the extension cable, use a
new one if necessary.
Check fuses / RCCB.
Have the power supply checked by
a qualified electrician.
Wait until the motor protection
switch switches the chain saw
back on.
Unlock the chain brake.
Check the oil tank for damage.
Check the oil level and top up with
saw chain oil if necessary.
Clean the oil entry hole and oil
guide groove.
39