Product Description - geberit EFP 202 Instrucciones De Servicio

EN

Product description

Structure
The Geberit pressing tool consists of:
• pressing tool incl. operating instructions
• pressing jaws or
• adapter jaws with pressing collars
• safety notes
• transport case
The equipment may vary depending on the scope of delivery.
1
2
3
5
4
6
7
1 Pressing tool
2 Swivelling pressing head
3 Pressing jaw
4 Retaining pin
5 Roller drive
6 Unlocking button
7 Start button
0
Function
An automatic pressing function makes sure that the press connection is completely finished.
For safety reasons, the automatic pressing function is not activated until a certain press
capacity has been attained (after approx. two seconds). The pressing sequence then
continues automatically. The pressing sequence can be interrupted by releasing the start
button [7]. Pressing the start button [7] again causes the pressing sequence to be resumed.
If the pressing sequence is interrupted, the Geberit pressing tool stops in the position that
has been reached. Pressing the unlocking button [6] causes the piston in the pressing tool
to return. The pressing tool can then be released from the pipeline.
The pressing tool functions electrohydraulically. As soon as the maximum press capacity has
been attained, the hydraulic valve switches off the pressing sequence.
The pressing tool has a swivelling pressing head [2]. This can only be swivelled before
pressing. To swivel the pressing head, hold the handle of the pressing tool and swivel the
front part of the pressing cylinder.
B966-003 © 05-2015
18
965.596.00.0 (02)