geberit EFP 202 Instrucciones De Servicio página 25

Cleaning and lubricating the Geberit pressing tool
Prerequisites
Pressing tool is de-energised.
WARNING
Risk of injury from switching on inadvertently
Disconnect the mains plug before starting any maintenance work on the pressing
tool
CAUTION
Damage to the device from dampness or moisture
Never immerse the pressing tool in water or other liquids
1
Clean the roller drive and retaining pin of the pressing tool.
2
Use compressed air or a brush to remove dirt.
3
Use BRUNOX® Turbo-Spray® or equivalent to lubricate the roller drive, its guide and the
retaining pin (see cover page in the back, figure D).
4
Wipe off any excess lubricant.
B966-003 © 05-2015
965.596.00.0 (02)
EN
25