Pre-Installation - K2 Pumps PPV10001SPK Manual Del Propietário

17. CAUTION: Use a supplier recommended primer to ensure glued joints are secure. Many local codes require
primer with a purple tracer to verify primer use.
18. CAUTION: Consider climatic conditions when applying adhesives. Atmospheric conditions with high humidity will
make the adhesive action of certain glues less effective. Follow the manufacturer's instructions.
19. CAUTION: This pump should be installed and serviced only by a qualified pool service professional. Installers,
pool operators and owners must read these warnings and all instructions in the owner's manual before using this
pump. These warnings and the owner's manual must be left with the pool owner.
20. IMPORTANT: Design the piping system to allow the pump suction inlet height to be as close to the water level as
possible. Mount the pump below water level for easy priming. If the pump must be located above the filled water
level, keep the vertical distance to a minimum. Use short, direct piping to the suction to minimize friction loss.
21. IMPORTANT: The motor of this pump has a thermal protector that will trip if the motor becomes too hot. The
protector will reset it-self once the motor cools down and an acceptable temperature has been reached. The
pump may start unexpectedly if it is plugged in.
22. IMPORTANT: Ensure the electrical power source is adequate for the requirements of the pump.
23. IMPORTANT: This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free
service for a long time when properly installed, maintained, and used. However, inadequate electrical power to
the pump, dirt, or debris may cause the pump to fail. Please carefully read the manual and follow the instructions
regarding common pump problems and remedies.
24. IMPORTANT: Provide sufficient ventilation to maintain air temperature below the maximum ambient temperature
rating shown on the motor nameplate. Any enclosure or pump house must allow adequate ventilation to assure
the ambient temperature remains below the motor rating when the pump is operating.

PRE-INSTALLATION

APPLICATION
This swimming pool pump is designed for use with permanently installed swimming pools only. A permanently installed
pool is constructed in or on the ground or in a building and is not intended to be disassembled or moved.
Do not use with storable portable pools. A storable pool is constructed so that it may be readily disassembled for
storage and reassembled to its original integrity.
TOOLS REQUIRED
Flathead
Screwdriver
Pipe Wrench
For Professional Technical Support call 1-844-242-2475
Phillips
Screwdriver
Hacksaw
Wrench
Tape Measure
Safety
Goggles
3