Pre-Installation; Tools Required; Package Contents - K2 Pumps WPS05003K Manual Del Usuario

WARNING: This pump is designed for indoor installation only. Failure to install indoors will significantly increase the
risk of injury or death from electrical shock.

PRE-INSTALLATION

APPLICATION
This unit is a single stage jet pump designed for shallow well applications, where the water level is less than 25 ft.
deep. If the water level to the pump is deeper than 25 ft., a convertible jet pump or a deep well submersible pump
should be used. A pressure switch pre-set at 30 PSI "on", 50 PSI "off" has been installed on the pump. The pressure
switch will automatically turn the pump on and off based on the system pressure.

TOOLS REQUIRED

Flathead
Screwdriver
Safety goggles
WARNING: All joints and connections must be AIRTIGHT. A single leak will prevent the proper operation of the pump.
Wrap thread tape clockwise on all threaded connections. For all non-threaded connections, you must use PVC Purple
Primer and PVC Cement to ensure airtight seals. Measure all pipe lengths before attaching.
NOTE: A foot valve is a check valve that is used to keep the water from running back into the well from the pump and
maintain hydraulic pressure when the pump is not running. If the foot valve does not hold the water the pump will lose
it's prime and will not pump water. If the foot valve open pressure is too high (the spring is too stiff), or the flow area is
too small, the pump suction head and flow rate will significantly drop.
NOTE: For SKU # WPS05003K, SKU #WPS07503K, the suction pipe size should not be less than 1-1/4 in. the
suction size of this pump is 1-1/4 in. FNPT. For SKU # WPS05002TK, the suction pipe size should not be less than 1
in. the suction size of this pump is 1 in. FNPT.

PACKAGE CONTENTS

For Professional Technical Support call 1-844-242-2475
Phillips
Screwdriver
Tape Measure
Wrench
Thread Tape
A
3