CTA HCAT TE 0011 Manual De Instalación Y Mantenimiento página 66

ACTIVATING AND DEACTIVATING THE UNIT
Heating and cooling functions are enabled and disabled via
the control panel.
SETTING AND DISPLAYING SERVICE PARAMETERS
DISPLAYING SERVICE PARAMETERS
To display service parameters, proceed as follows:
- press the ON-OFF key;
- press the ON/OFF and MODE keys together for one
second;
1 2
t P
HSA3
the tP parameter appears on the display;
use the and
ter;
- press the ON/OFF and MODE keys together for one
second;
1 2
t0 1
HSA3
the t01 parameter appears on the display;
- press the ON/OFF and MODE keys together for one
second;
1 2
HSA3
the value of the t01 parameter appears on the display.
Parameter
tP
Err
PAr
Pss
OHr
Note: while the parameters are being set, the COMPRESSOR and ELECTRIC RESISTOR LEDs flash, alternating with
the DEFROSTING LED.
28 English 07/03
mode
set
on
off
keys to select another parame-
mode
set
on
off
mode
1
set
on
off
LIST OF ACCESSIBLE - DISPLAYABLE PARAMETERS
Description
Operating status
Alarm
Operating parameters
Password
Hours of operation
To activate and deactivate the unit, see page 23.
Use the and
1 2
HSA3
- press the ON/OFF and MODE keys together for two
seconds;
1 2
t0 1
HSA3
- press the ON/OFF and MODE keys together again for
more than two seconds;
1 2
HSA3
- press the ON/OFF and MODE keys together again for
more than two seconds;
1 2
HSA3
The word "On" is displayed, together with either the heat-
ing or cooling LED depending on the mode selected.To dis-
play the unit status values, alarms and number of hours
operation, return to the tP level, then follow the procedure
described above, choosing the number required using
the and .
Unit of measurement
Value
Value
Value
Value
Value
U I A
A
keys to set a new value;
mode
2
set
on
off
mode
set
on
off
mode
t P
set
on
off
mode
set
on
off
Factory set point
-
-
-
-
-
HCAT TE - HCAN TE