Publicidad
For Permanent Mount Installation go to page (6)
Step 1 and 2 - Tension Installation
• STEP 1: Locate the end cap and mounting bracket labeled (A) and CLICK them together. NOTE: Make sure
the directional stickers are pointing in the same direction.
• Following the directional sticker UP ARROW and connect rod (A) to the mounting bracket (A) by pushing the
tube into the mounting bracket against the floor until the rod and mounting bracket CLICK together.
• STEP 2: Repeat these steps to connect the rod and mounting bracket labeled (B).
LEFT SIDE (A)
RIGHT SIDE (B)
B
A
A
B
CLICK
CLICK
3
1-800-892-3986
IS19172-I2
Publicidad
