Publicidad
Step 3A - Tension Installation
• Turn the rod (A) upside down and locate the screw position areas.
• Using the included allen wrench (E), LOOSEN the attached set screws (F) to allow rods to expand smoothly.
• NOTE: Do not remove the set screws (F).
Step 3B - Tension Installation
• Insert the end of the 7/8 in. diameter tube assembly (B) into the end of the 1 in. diameter tube (A), fig 1.
• Once connected, wipe the rubber pad on each mounting bracket (A and B) clean, fig 2.
set screws
facing DOWN
4
E
A
A
loosen set screws (F)
fig. 1
fig. 2
TO P B
2
mounting bracket (A and B) clean.
B
PU SH AG AI
NS T
F LO OR
B
Wipe the rubber pad on each
1-800-892-3986
IS19172-I2
Publicidad
