Cleaning & Maintenance; Disposal Instructions - Renfert AUTO spin Guia De Inicio Rapido

Adjusting the drilling depth
⇒ Switch off the device and disconnect it from the power supply.
⇒ Remove drill (see Chapter "Changing the drill").
EN
⇒ Insert the drilling depth adjusting tool (11) into the drill chuck
from above and adjust the stop screw on the inside:
⇒ turn left
♦ Drill hole diameter gets larger.
♦ Pin sits deeper in plastic plate.
⇒ turn right
♦ Drill hole diameter get smaller.
♦ Pin sits more shallow in plastic plate.
One entire revolution of the stop screw changes the drilling
depth by 0.45 mm.
A practicable setting is achieved when the inserted pin is
flush with the plastic plate when the desired press-in pres-
sure is applied.
Cleaning / Maintenance
The device does not contain any internal parts that require maintenance.
Cleaning
⇒ Only wipe the housing with a damp cloth.
⇒ Regularly remove loose plastic chips.
Do not use solvents or abrasive cleaners.
Changing the drill
⇒ Switch off the device and disconnect it from the power supply.
⇒ Turn the drill mount with your fingers until the mark on the drill
chuck points to the side.
⇒ Use the L-key (12) to loosen the fastening screw until the drill
moves (about 1/2 turn).
⇒ Remove drill upwards.
⇒ Insert new drill.
⇒ Re-tighten fastening screw.
Screw in the screw as far as it will go and then tighten about
1/8 turn.
Spare parts
You can find components subject to wear and the spare parts on the spare part list in
the internet at www.renfert.com/p918. Enter the following item number: 18600000.
The components excluded from the warranty (such as consumables or parts subject
to wear and tear) are marked on the spare part list.
Serial number and date of manufacturing are shown on the type plate of the unit.

Disposal Instructions

Within the European Union units with this symbol should not be disposed of in
unsorted domestic waste.
For more information regarding proper disposal please apply at your local authorities.
- 4 -
11

L
L
12
Subject to alteration