Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Place the 3600 light into the bezel.
4.
Position the self-adhesive side of the inner gasket onto the retainer.
5.
Carefully place the gasket/retainer assembly over the 3600 series light.
Position the assembly inside the aluminum bezel, while aligning the retainer mounting
screw hole locations.
6.
Secure the gasket/retainer assembly to the aluminum bezel with the
supplied #6-32 screws.
7.
Align the bezel and mounting gasket over the previously drilled holes
and secure with the supplied #8 pan head screws.
IV.
ELECTRICAL.
The unit is designed to operate on a 12.8VDC system and designed to work with
Federal Signal flashers. Two wires exit the unit. They are as follows: red (positive) and
black (negative). Using user-supplied connectors and 18AWG minimum wire, refer to
the particular flasher instructions for proper wiring.
The positive red wire must be appropriately fused at 1 amp. This
unit is not reversed polarity protected unless properly fused. Federal
Signal is not responsible for any improper wiring.
This unit is designed for flashing applications (40% duty cycle) only.
This unit is not designed to operate in constant mode.
V.
MAINTENANCE.
1.
General.
Crazing (cracking) of lenses will cause reduced effectiveness of the
light. Do not use cleaning agents (which will cause crazing) such
as strong detergents, solvents, or petroleum products. If crazing of
lenses does occur, reliability of light for emergency signaling pur-
poses may be reduced until lenses are replaced.
Ordinary cleaning of the plastic lenses can be accomplished by using mild
soap and a soft rag. Should fine scratches or a haze appear on a lens, they can ordinar-
ily be removed with a mild, high quality, automotive rubbing compound.
2.
Service.
The Federal factory will provide technical assistance with any problems that
cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be
accompanied by a Return Material Authorization. This R.M.A. can be obtained from a
local Distributor or Manufacturer's Representative.
-4-
Publicidad
