Siemens SITRANS LR 300 Guía Para La Puesta En Marcha página 8

Switching to PROGRAM mode: steps 1 and 2
1.
The unit starts in RUN mode:
Readings correspond to existing
settings.
Accessing a Parameter: steps 3, 4, and 5
Scroll to the parameter number, or use Direct Address to access a parameter.
3.
Press the TOGGLE key
to display the Parameter
Number field.
Changing a Parameter value: steps 6 and 7:
6. Key in the new value.
Example: press
7. Press the ENTER key
Note:
Values shown are for demonstration purposes only.
Resetting Parameters to Factory Setting (individually)
1. Scroll to the parameter or enter its address.
Press the CANCEL key
2.
appears.
Press the ENTER key
3.
disappears.
Quick Start Programming: steps 1, 2 and 3
1. Configure all parameters to their factory settings via P999 Master Reset:
Press the PROGRAM key
a.
b. Press the TOGGLE key
c. Key in 999.
Press the CANCEL key
d.
reset.
e. Reset complete. (Note: Reset takes several seconds to complete.)
Page EN-6 SITRANS LR 300 – QUICK START MANUAL
2.
Press the PROGRAM key
activate the PROGRAM mode: the
number fields go blank.
4.
Press the TOGGLE key
again to open the Parameter
Number field. The Parameter
Number field goes blank and
the EDIT icon
. The new value and the EDIT icon
to set the value. The EDIT icon disappears.
. The value field goes blank and the EDIT icon
. The value returns to factory default and the EDIT icon
to activate the PROGRAM mode.
twice to access parameter fields.
followed by the ENTER key
5.
Key in the desired
parameter number:
Example:
The new parameter
appears. number and value appear.
appear.
to Clear All and initiate
to
.
Value
7ML19985QA81