SETTING UP
WHEN ONE TRANSMITTER IS USED
1.
First, insert the batteries in the transmitter (see "How to install and replace batteries in the thermo-
hygro outdoor transmitter" above).
2.
Within 2 minutes of powering up the transmitter, insert the batteries in the weather station (see "How to
install and replace batteries in the weather station" above). Once the batteries are in place, all
segments of the LCD will light up briefly and a short signal tone will sound. Following the indoor
temperature/humidity and the time as 0:00 will be displayed. If these information are not displayed on
the LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting
them. Once the indoor data is displayed user may proceed to the next step.
3.
After the batteries are inserted, the weather station will start receiving data signal from the transmitter.
The outdoor temperature and humidity data should then be displayed on the Weather station. If this
does not happen after 2 minutes, the batteries will need to be removed from both units and reset from
step 1.
4.
In order to ensure sufficient 868 MHz transmission however, the distance between the weather station
and the transmitter should not be more than 100 meters (see notes on "Positioning" and "868 MHz
Reception").
44