Connecting The Battery Pack To The Inverter; Wiring Of Dc Wire - Ingeteam INGECON SUN STORAGE 1Play TL M Manual De Uso Y Configuración

Ingeteam

2 Connecting the battery pack to the inverter

This chapter describes how to connect the ISS 1Play to the BYD B-BOX Premium HVS/HVM.
Please, take into account the following technical notes:
1) The inverter is turned OFF before connecting the battery pack to the inverter.
2) The battery circuit breaker is on the OFF position.
3) Connect the DC power wires with 10mm
4) Connect the CAN Communication wire using, for example, an Ethernet cable without
the RJ45 terminals.
2.1

Wiring of DC wire

1. Pass the wires through the dedicated cable grommet, respecting the polarities.
2. Remove the M5 bolts and connect the wiring to the terminals marked as J105
BATTERY + and J106 BATTERY –
3. Tighten the M5 bolts with a torque of 2.5Nm.
4. Check the connection is tight.
Use and settings of the INGECON SUN STORAGE 1Play TL M working with BYD B-BOX
Premium HVS/HVM
2
ISS 1Play TL M
.