Stalgast 803021 Instrucciones De Uso página 33

Lavavajillas de campana
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 52
2. Button functions
Fig. 6
3. Starting the appliance
Activate the switch placed on the wall and press the On/Off (Fig. 7). Then open the hood of the dishwasher,
put the overflow plug in place (Fig. 6), put the basket into the chamber and select the program (Fig. 10).
After closing the hood, the appliance will start filling its tank and the boiler with water - the boiler pilot light
will illuminate (Fig. 9). Once the water in the boiler is heated up, the dishwasher chamber starts heating up
the water - a pilot light of the heater compartment light will illuminate (Fig. 9). The washing cycle will start
automatically - the indicator light will illuminate (Fig. 8). If you open the door during the wash cycle, the pro-
gram stops automatically. After closing the door, the program continues the wash cycle. After completing
the program, the wash cycle indicator light turns off (Figure 8). Remove the basket from the chamber of the
appliance. Note! Each operation that involves closing the hood starts a new dishwashing cycle.
4. Emptying the tank in models equipped with a drain pump
Switch off the appliance by pressing the On/Off switch (Fig. 7), then open the hood of the appliance, remo-
ve the overflow plug (fig. 6) and close the hood. The drainage process begins automatically and continues
until the tank is completely emptied of water. In order to activate the appliance place the overflow plug back
in its place, close the hood of the appliance, and then press the power button. However, if the appliance is
not already in use, turn off the main switch.
5. Emptying the tank in models not equipped with a drain pump
Switch off the appliance by pressing the On/Off switch (Fig. 7), then open the hood of the appliance, remo-
ve the overflow plug (fig. 6) and wait until the water leaks from the tank completely. Place the overflow plug
back in its place, close the hood of the appliance.
In the event of ending work with the appliance, after performing the above, it is mandatory to switch
off the device by pressing the switch and then turning off the main switch and close the water tap.
6.4. WASHING PROCEDURES (803035, 803036, 803037)
1. Control panel
Fig. 7
On/O
Fig. 8
Fig. 9
Wash cycle
Indicator
light for cham-
ber and boiler
heaters
- 33 -
Fig. 10
Selecting program
2 - 120 sec. / 3 - 180 sec.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

803035803036803037

Tabla de contenido