Punching And Binding With Plastic Combs - Esselte LEITZ comBIND 500 Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 29
1
2
3
4
5

Punching and binding with plastic combs

1. Preparations
• Set the paper stop
• Determine the comb size needed by holding the document
(including front and rear cover) in position on the comb size
scale
.
H
You may also use the table on page 5 for this purpose.
• Set the punching depth
2. Inserting and opening the comb
• Place the plastic comb with the side to be opened facing upwards
into the binding mechanism
• Pull the binding lever
that the sheets can be easily inserted.
3. Punching the sheets
Tip: We recommend testing the punch setting using a blank sheet of paper
before punching the original docu ment.
Caution! To prevent damage to the punching mechanism,
remove all metal parts (staples etc.) from the document before
punching. Do not punch more than 25 sheets of 80g/m² paper or
two films of 0.2 mm at the same time. Also, empty the cuttings
tray regularly.
Caution! Risk of squeezing fingers. Take hold of the punching
lever with both hands in the middle of the grip plate. Keep other
people away from unit when punching.
• Insert the sheets into the rear slot
• Pull the punching lever
• Push the lever up again and remove the punched sheets.
4. Inserting the sheets
• Insert the punched sheets into the opened comb.
It is now possible to punch all remaining sheets (step 3) and insert them into
the opened comb.
5. Removing the finished document
• Push the binding lever
• Remove the finished document.
to the paper format used.
B
according to the comb size determined.
F
.
G
so far until the comb is opened enough so
I
.
D
all the way down.
E
backwards to close the comb.
I
7
 

Publicidad

Tabla de contenido
loading

Tabla de contenido