Dell PowerEdge R420xr Manual De Instrucciones página 14

Securing the PCIe Card on Riser 2
1 Locate and remove the PCIe card on riser 2.
2 Unfasten the screw on the PCIe card and install the electrical insulator
tape on the PCB as shown in Figure 1-8.
NOTE:
PCIe card.
3 Locate the riser 2 bracket assembly (DPN: FYGC8).
NOTE:
that hold the plastic bracket and the metal bracket to separate the two
components.
4 Place the plastic block on the system board adjascent to riser 2 such that
Point A is aligned with the PCIe connector as shown in Figure 1-8.
5 Install the PCIe card on riser 2.
6 Slide the plastic block with point A sliding along the PCIe riser connector,
and point B beneath the PCIe card as shown in Figure 1-8.
NOTE:
that hold the plastic bracket and the metal bracket to separate the two
components.
7 Align the screw holes on the metal bracket with the screw holes on the
PCIe card and the plastic bracket as shown in Figure 1-8.
NOTE:
screw holes are aligned with that on the plastic bracket.
8 Place riser 2 metal bracket on PCIe card and secure using a screw as shown
in Figure 1-8.
9 Secure the metal bracket to the plastic bracket using the two screws.
12
Installation Guide
Make sure that the hole on the tape is aligned with the hole on the
The riser 2 metal bracket comes as an assembly. Loosen the screws
The riser 2 metal bracket comes as an assembly. Loosen the screws
Adjust the position of the plastic bracket such that the metal bracket