Ocultar thumbs Ver también para SUGO Serie:

Publicidad

Enlaces rápidos

SG08-LITE

Publicidad

Tabla de contenido
loading

Resumen de contenidos para SilverStone SUGO Serie

  • Página 1 SG08-LITE...
  • Página 2 In contrast with its relatively small size, the SG08-LITE supports standard ATX PSU for greater selections and when used with SilverStone’s Strider Gold S series, the smallest full modular power supplies with 80 PLUS Gold in the world, or our carefully engineered SFX PSUs, the SG08-LITE can help you create an incredible Mini-ITX system.
  • Página 3: Disassemble Chart

    Disassemble chart HDD CAGE 3.5” HDD X 1 (OPTION) TOP COVER EXPANSION SLOT X 2 2.5” HDD X 2 (OPTION) FAN BRACKET SLIM OPTICAL DRIVE (OPTION) USB 3.0 + SPK + MIC POWER BUTTON MINI-ITX (OPTION) POWER LED & HDD LED ATX PSU (OPTION) FAN FILTER PSU FILTER...
  • Página 4 Installation Guide Выкрутите крепежные винты Unscrew screws holding the top верхней крышки, а затем снимите cover and then remove it by pulling ее, потянувназад и в сторону от to the rear and away from корпуса. the chassis. Lösen Sie die Schrauben an der 상부커버를...
  • Página 5 Installation Guide Выкрутите крепежные винты Unscrew screws holding the кронштейна привода оптических optical drive bracket to дисков, чтобы извлечь его. remove it. Entfernen Sie die Abdeckung des 광드라이브 브라켓을 고정하고 있는 optischen Laufwerks, indem Sie 나사를 풀어 브라켓을 제거합니다 die in der Abbildung gezeigten Schrauben lösen.
  • Página 6 Installation Guide Insert the I/O shield included Установите экранированную панель ввода/вывода системной with your motherboard and then платы, а затем установите саму install the motherboard into системную плату. the case. 메인보드 후면 I/O 커버를 설치한 후 Setzen Sie das mit Ihrem 메인보드를...
  • Página 7 Installation Guide We recommend at this point to start thinking about routing the cables cleanly by fastening ATX 24pin and EPS 8pin/ATX 4pin cables on a bridge next to the power supply bracket. You may need to store excess cables in the area located on the left side of the hard drive cage. Wir empfehlen, an dieser Stelle eine saubere Kabelführung zu beachten, indem Sie die 24-poligen ATX- und 8-poligen EPS-/4-poligen ATX-Kabel an einer Brücke neben der Netzteilhalterung befestigen.
  • Página 8 Installation Guide We recommend to route the USB and audio front I/O cables around the front of hard drive cage, there should be sufficient bridges for fastening the cables. Wir empfehlen die Führung der USB- und E/A-Audiofrontkabel um die Vorderseite des Festplattenkäfigs; es sollten genügend Brücken zur Befestigung der Kabel vorhanden sein La longueur de câble superflu peutêtre dissimulée sur le côté...
  • Página 9 Installation Guide Excess front panel connector Излишки кабелей к разъемам cables can be fastened on передней панели можно закрепить the bottom panel of the case. на нижней панели корзины. 불필요하거나 남는 패널커넥터와 Die restlichen Frontblenden- 케이블은 케이스 하부 패널에 Anschlusskabel können an der 고정하면...
  • Página 10 Installation Guide Install and secure the hard drive Установите и закрепите корзину cage with screws. жестких дисков винтами Installieren und befestigen Sie den 하드 드라이브 케이지를 설치한 후 Festplattenkäfig mit Schrauben. 나사로 고정합니다. ハードドライブケージを取り付け、 Réinstallez le casier à disques durs ネジで固定します。...
  • Página 11 Installation Guide We recommend connecting all fan or SATA cables to the motherboard now as installation of graphics or expansion card may prevent installation of these cables. Wir empfehlen, nun alle Kühler- oder SATA-Kabel am Motherboard anzuschließen, da die Installation der Grafik- oder Erweiterungs- karte die Verbindung dieser Kabel erschweren oder verhindern kann.
  • Página 12 Installation Guide Remove expansion slot screws to remove expansion slot covers. Lösen Sie zum Entfernen der Abdeckung die Schrauben des Erweiterungssteckplatzes. Retirer les vis des slots d’extension pour retirer les caches. Quite los tornillos de las ranuras de expansión para retirar las cubiertas de las ranuras de expansión.
  • Página 13 Installation Guide Install graphics or expansion card Установите графическую карту или плату расширения в корпус, а затем into the case then connect any подключите к плате все required power cables to the card. необходимые кабели питания. Installieren Sie die Grafik- oder 그래픽카드나...
  • Página 14 Installation Guide Install slim optical drive onto the IУстановите тонкий привод optical drive bracket and secure оптических дисков на with included screws. специальный кронштейн и закрепите прилагающимися винтами. 슬림 광드라이브를 광드라이브 Installieren Sie ein schmales 브라켓에 설치한후 나사로 optisches Laufwerk an der Halterung 고정합니다.
  • Página 15 Installation Guide Place the top cover back onto the case and secure with screws. Platzieren Sie die obere Abdeckung wieder am Gehäuse und befestigen diese mit Schrauben. Remettre en place le capot supérieur du boitier et le fixer à l’aide de vis. Vuelva a poner la cubierta superior en la carcasa y fíjela con tornillos.
  • Página 16: Connector Definition

    Connector definition (1) Front panel connector installation no polarity, so they can be connected in any orientation Power switch and reset switch installation guide: Please refer to the motherboard manuals for the motherboard’s “Front Panel Connector” or “System Panel Connector” pin definitio Power switch and reset switch have no polarity, so they can be connected in any orientation.
  • Página 17 Connector definition LED indicators installation guide Please refer to the motherboard manuals for the motherboard’s “Front Panel Connector ” or “System Panel Connector” pin definition.; the white/black wires are negative while other colors are positive wires. The Power LED wires are separate pins for compatibility with different motherboard pin definition so please make sure they are connected in the right polarity by referring to your motherboard manual.
  • Página 18: Front I/O Connector Guide

    A continuación tiene la definición de pines de los conectores frontales de E/S, también debe consultar el manual de su placa base para c omprobar la referencia de los pines para E/S frontales. Los conectores de E/S de SilverStone son de bloque para simplificar la instalación.
  • Página 19: Component Size Limitations

    Component size limitations The SG08-LITE can accommodate all standard size components and even some that are out of spec, please refer to the following guidelines for component selection and future upgrade considerations. (1) CPU cooler height limitation CPU cooler height limitation 147mm (2) PSU limitation Depth limitation Power supply depth limitation 140mm...
  • Página 20 Component size limitations Accepte les blocs d'alimentation au standard ATX jusqu'à une longueur de 160mm. Pour accepter une longue carte graphique (de plus de 7,25”), la dimension du bloc d'alimentation ATX est limitée à 140mm, et uniquement aux blocs d'alimentation non modulaires. Les câbles doivent se trouver à...
  • Página 21 Блок питания мощностью свыше 800 Вт устанавливать не рекомендуется из-за кабеля адаптера. 어댑터 케이블 때문에 800w 이상의 PSU는 권장하지 않습니다. 800wを超えるPSUはアダプタケーブルの関係上お勧めできません。 因為轉接線的原因,不建議安裝超過800W的電源 因为转接线的原因,不建议安装超过800W的电源 Recommended SilverStone’s PSU (support the installation of long graphic card) SFX Series (ATX adapter included) Strider Essential Series Compatible SilverStone’s PSU...
  • Página 22 Component size limitations (3) Graphics card/expansion card length limitation Graphics card / expansion card length limitation SG08-LITE can support 12.2”consumer-level graphics cards (width 4.84”). Due to design, the graphics or expansion card when installed will be situated very close to the power supply so we recommend using cards with backside components no taller than 3.21mm. Most cards that follow standard reference designs should have no compatibility problems.
  • Página 23 Component size limitations (4) Optical drive limitation The SG08-LITE only supports 12.7mm slim optical drives. Below is an example of 12.7mm optical drive. Das SG08-LITE unterstützt nur schmale optische Laufwerke Nachstehend finden Sie Beispiele zu optische 12,7 mm-Laufwerke. Le SG08-LITE est compatible seulement avec le lecteur optique slim sans tiroir de 12,7mm Un exemple de lecteur optique de 12,7 mm est présenté.
  • Página 24: Optimal Thermal Performance Layout

    Optimal Thermal Performance Layout Using SilverStone’s NT06-PRO without CPU fan is possible on CPU with TDP rated up to 95W. With a 120mm fan installed on the NT06-P, the use of a CPU with TDP rating of up to 130W is possible. We recommend using SATA connector with 90 degree angle for the 3.5” hard drive in order to use larger CPU cooler such as SilverStone’s NT06-P or bigger.
  • Página 25: Cable Routing

    Optimal Thermal Performance Layout Cable routing We placed pass-through holes on the back of the case, please use wire ties in places as needed by your hardware configuration. Hinter dem Motherboard-Einschub befinden sich Haken, die der Verwendung von Kabelbändern dienen. Il y a des crochets derrières le support de la carte mère pour utiliser des attaches pour regrouper les câbles.
  • Página 26: Maintenance And Upgrade

    Maintenance and upgrade Fan and fan filter disassembly guide If you need to change fans, clean, or upgrade a fan, please refer to the following steps: 1. Unscrew screws holding the fan bracket and then pull up and away from the case. 2.
  • Página 27 Maintenance and upgrade 1. Выкрутите крепежные винты кронштейна вентилятора, а затем потяните его вверх и в сторону от корпуса. 2. Снимите фильтр вентилятора размером 180 мм, как показано на рисунке. 3. Выкрутите четыре крепежных винта вентилятора и два крепежных винта предохранительного кронштейна графической карты/платы расширения.
  • Página 28 Maintenance and upgrade La conception à pression d'air positive du SG08-LITE est une configuration efficace permettant de réduire l'accumulation de la poussière dans le boîtier. De petites particules d'air ou de peluche vont s'accumuler avec le temps sur les filtres d'aspiration, et non sur les composants à l'intérieur du boîtier.
  • Página 29 Maintenance and upgrade 1. After removing the top cover, the 180mm fan filter can slide out easily. 2. Flip the entire case upside-down, unscrew the screws holding the power supply filter to remove it. 1. Nach der Entfernung der oberen Gehäuseabdeckung können Sie den 180 mm-Lüfterfilter einfach herausziehen. 2.
  • Página 30 Recommended SilverStone products SST-SOB02 SOB02 is a slot-loading slim DVD burner with included SATA adapter and cable SST-NT06-PRO NT06-PRO offers high performance cooling with specific space requirements SST-SDP08 Use SDP08 to convert an available 3.5" drive bay into two 2.5" drive bays.
  • Página 31: Warranty Information

    Replacement product will be warranted for remainder of the warranty period or thirty days, whichever is longer. All products should be sent back to the place of purchase if it is within 30 days of purchase, after 30 days, customers need to initiate RMA procedure with SilverStone Technology in USA by first downloading the “USA RMA form for end-users”...
  • Página 32 NO:G11220721...

Este manual también es adecuado para:

Sugo sg08-liteSst-sg08b-lite

Tabla de contenido