Glass Cleaning; Fireplace Surface Cleaning - Dimplex DCF44GS Manual Del Propietário

Maintenance
wire harness.
8. Replace the logset by
inserting the front edge of
the fireplace and push down
on the rear edge of the
emberbed until it snaps into
place (Figure 6).
!
NOTE: Ensure the logset is
installed tightly under the back
ledge to prevent light leakage.
9. Replace glass assembly.
Upper Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
15 Watt rating.
Do not exceed 15 Watts per
bulb
To access the upper light bulb
area (Figure 5):
1. Remove front glass assembly.
2. Remove upper light cover.
3. upper bulbs located in the
upper left and upper right
corners of fireplace (Figure
5).
4. unscrew bulbs counter
clockwise.
5. Insert new bulbs.
6. Re-install upper light bracket.
7. Replace glass assembly.
14
Figure 6
Back
Ledge
Rear
Tab
Side Section

glass Cleaning

The glass is cleaned in the factory
during the assembly operation.
During shipment, installation,
handling, etc., the glass may
collect dust particles; these can
be removed by dusting lightly with
a clean dry cloth.
To remove fingerprints or other
marks, the glass can be cleaned
with a damp cloth. To prevent
scratching, do not use abrasive
cleaners or spray liquids on the
glass surface.
Fireplace Surface
Cleaning
use a cloth dampened with
warm water only to clean painted
surfaces of the electric fireplace.
Do not use abrasive cleaners.
Log
Ember bed
Front
Edge
www.dimplex.com