Remote Control Functions - Dimplex DCF44GS Manual Del Propietário

Ocultar thumbs Ver también para DCF44GS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
Remote Control Initializing/
Reprogramming
1.
Plug cord into 120 Volt wall
outlet.
2.
Ensure the on/off switch
located in the switch box on
the fireplace in the upper right
hand corner is in the
position.
3.
Set the 3 position manual
control to the Remote
position (right position).
4.
Press and hold the
initialization button on the
unit.
5.
While holding the initialization
button, press the Flame/Heat
on/oFF
remote control.
6.
Release the initialization
button on the unit.
7.
Press the Flame/Heat on/off
button
Heat function on.
Frequency Interference
If the fireplace does not respond
properly to the remote control,
the remote operating frequency
may have to be reset. The
remote control can send another
frequency code to the circuit
board to eliminate interference.
10
button on the
to turn the Flame/
1.
Simultaneously press the
"Temperature Down" button
and the "Flame Speed
Down" button on the remote
control.
2.
"
the sleep timer digits.
3.
Release the "
on
Down" button and the "Flame
Speed Down" button.
4.
Press the initialization button
on the unit.
5.
Press the
remote.
Your remote will now
have a different frequency
communicating with the fireplace.

Remote Control Functions

(all letter references are to Figure 3)
B. Set Temperature
Press F button to turn fireplace
on.
Press H to raise thermostat.
Press g to lower thermostat.
Press both H and g to change °F
to °C.
C. Dimmer
Press the F button
Flame/Heat ON.
Repeatedly press the J or I button
COD" will appear in place of
Temperature
button on the
to turn the
www.dimplex.com

Publicidad

Tabla de contenido
loading

Tabla de contenido