Base-To-Blade; Bevel Stop Adjustment - Skil 3315 Instrucciones De Funcionamiento Y Seguridad

SM 2610012178 08-10:2610007743 07-09 3315 8/23/10 10:13 AM Page 36
Adjustments
Base-To-Blade Adjustment
Make sure blade is perpendicular to the base.
1. While lowering the blade, hold a combination square 1
against the base 2 and next to the blade 3 (Figure 15).
Avoid touching the saw teeth with the square. The set in
the blade's teeth will hold the square away from the
blade. The blade should contact the full length of the
square.
2. If the blade does not contact the full length of the square,
adjust the bevel adjustment screw:
Loosen the bevel adjustment locknut 4 (Figure 16).
Hold the square against the base. Rotate the bevel
adjustment screw 5, up or down, until the full length of the
square is against the blade. Tighten the bevel adjustment
screw locknut 4.
3. Make sure the bevel indicator is aligned with the bevel
index 0° mark. If adjustment is necessary, loosen the
bevel indicator screw 6 until the indicator aligns with the
0° mark (Figure 17).
4. Tighten the bevel indicator screw 6.

Bevel Stop Adjustment

Make sure the bevel indicator aligns with the bevel index 45°
mark when the handle assembly is against the bevel stop
screw. If adjustment is necessary:
1. Loosen the bevel lock knob.
2. Loosen the bevel stop locknut 1 (Figure 18).
3. Rotate the bevel stop adjustment screw 2, up or down,
until the bevel indicator aligns with the bevel index 45°
mark.
4. Tighten the bevel stop locknut 1.
1
2
1
36
FIG. 15
3
2
FIG. 16
5
4
FIG. 17
6
FIG. 18