Installing A New Bag - KENMORE ELITE 665.1473 Serie Manual De Uso Y Cuidado

If you have a plastic bag, remove top of bag from bag
retainer buttons. Close bag with a twist tie.
Remove bag from retainer
buttons.
3. Release drawer side latch. Tilt right drawer side down. This
will make removing the full bag easier.
4. Lift bag by bag caddy handles. Remove trash bag from
compactor and dispose properly.
NOTE: Fully compacted trash bags will be heavy. Handle
with care.
A. Lifting bag caddy by handles
Close bag with twist tie.
A

Installing a New Bag

Do not use any kind of bag other than those designed especially
for use in your compactor. Order replacement compactor bags
through your local dealer. See "Accessories."
IMPORTANT:
Before installing a new bag, be sure:
The drawer side is securely locked.
The container is clean and free of debris.
To install a new bag
1. Close drawer side. Lock drawer side latch.
2. Put bag caddy into drawer.
A. Bag caddy inside drawer
3. Place either a plastic or paper bag into the drawer.
If using a paper bag, open bag and pull top edges over
the drawer top. Slide front edge of bag over front edge
of drawer. Slide rear edge over rear of drawer.
If using plastic bag, open bag and pull top edges over
drawer top. Lock bag into place by pulling the
4 prepunched holes over the bag retainer buttons. Holes
will expand over buttons without harming bag.
Installing paper bag
4. Press inside of bag against the drawer bottom, sides and
corners for a smooth fit.
A
Installing plastic bag
11