Compactor Care; Cleaning - KENMORE ELITE 665.1473 Serie Manual De Uso Y Cuidado

Your new compactor is designed to give you many years of
dependable service. However, there are a few things you are
expected to do in order to properly maintain your compactor.
This section will tell you how to clean and care for your
compactor.

Cleaning

Before cleaning the compactor, turn the Key-Knob (or Key-
Switch) to the OFF & LOCK position and remove it.
NOTE: Any services other than those outlined in this section
should be performed by a designated service representative.
Cleaning Exterior Surfaces
1. Wash exterior surfaces (including stainless steel) with a
clean sponge or soft cloth and a mild detergent in warm
water. Do not use abrasive or harsh cleaners. Rinse and dry
thoroughly with a soft cloth.
2. Wipe up spills right away. Some foods can damage the
finish if left on the compactor surface.
Cleaning Inside the Drawer
NOTE: You may want to wear gloves since there may be bits of
glass in the drawer.
1. Remove the bag. See "Removing a Filled Bag."
2. Press down on the lever-action lock (or Side-Lock latch).
3. Hold the lever-action lock down and tilt the side of the
drawer out until the lock clears the drawer front.
NOTE: If desired, the drawer side can be removed by tilting
it up, then lifting it out.
4. Wash the interior of the drawer with a clean sponge or soft
cloth and a mild detergent in warm water. Rinse and dry
thoroughly with a soft cloth.
5. If the drawer side was removed, slide it back into the tilted
position.
12

COMPACTOR CARE

6. Press the lever-action lock (or Side-Lock Latch) down while
7. Latch the drawer side by pushing up the lever-action lock (or
Cleaning Inside the Cabinet
NOTE: You may want to wear gloves since there may be bits of
glass in the cabinet.
1. Pull the drawer out until it stops.
2. Lift the front of the drawer to clear the stops.
3. Grasp the drawer on the sides and pull it out the rest of the
4. Vacuum the inside of the cabinet. Liquid spills or wet trash
5. Wash the inside of the cabinet with a clean sponge or soft
6. To replace the drawer, grasp it by the sides and insert the
7. Lift the front of the drawer and push it in fully past the stops.
pushing the drawer side to the upright position.
Side-Lock Latch).
NOTE: Look to see how the drawer rollers move in the
tracks. It will be easier to replace the drawer after you have
finished cleaning.
way. Set the drawer down gently.
should be cleaned up by hand, or by using a vacuum
designed to pick up liquids.
cloth and a mild detergent in warm water. Rinse and dry
thoroughly with a soft cloth.
rollers onto the tracks.