Risk Of Injury; Special Notes; Product Overview - Formula 1 PJ125 Manual De Uso Original

Risk of chemical burns!
•
Risk of eye injuries. Wear safety goggles and do
not lean over the battery. The electrolyte of the
drained starter battery will still be liquid in low
temperatures.
Risk of electrical shock!
Failure to follow all instructions listed below may
result in electric shock, fire, serious injury and
damage to property.
•
Never use the cable to carry or pull the device.
•
Only unplug the cable from the outlet by the
plug. The cable could be damaged.
•
Do not use device if damaged. Damage to the
device or the charging cable increases the risk
of electrical shock.
•
Route the electrical cable so that it is not
possible to trip over them and to prevent them
being damaged.
•
Maintenance work must be done by qualified
electricians.
•
Avoid pouring or dripping water or other liquids
over it. If water penetrates electrical devices,
the risk of electric shock increases.
•
Ensure that all plugs and cables are free of
moisture. Never connect the device to the
mains with wet or moist hands.
•
Only connect 230 V devices with permitted
power plugs.
•
Never create a short circuit or bridge on the
inputs and outputs of the power inverter using
foreign objects.
•
Do not attempt to disassemble or repair the
device. Immediately have the device repaired or
replaced by a specialty shop if defective.
•
Do not cover the device as it may be damaged
from extreme heating.
•
Immediately stop using the device if you notice
smoke or an unusual odour.
•
Do not allow the clamps involved to touch.
•
Never allow the contacts of the lead connected
to the battery's positive terminal to come into
contact with electrically conductive vehicle
parts.
•
The vehicle bodies must not come into contact.

Risk of injury!

•
Do not modify or manipulate the product as
this will increase the risk of injury.
•
The high-pressure hose becomes hot during
use. Therefore allow it to cool down before
touching it and rolling it up.
•
Do not use the compressor for more than 6 mi-
nutes. Then allow it to cool down for approx. 10
minutes. Overheating and permanent damage
may otherwise occur.
•
Please also note the operating instructions of
connected devices.

Special notes

•
Do not inflate objects beyond the intended or
specified pressure. The object could burst.
•
Never inflate larger objects such as lorry or
tractor tyres, air mattresses or rubber boats.
This exceeds the delivery rate, thus the run-
time of the compressor.
•
The pressure specifications of the manometer
are reference values. Check the pressure with a
calibrated air gauge.
•
The max. pressure of 150 PSI (10.3 bar) will
only be reached if the pump volume is not
greater than 0.5 L.
Produc t Over-
view
1. „12V" button
2. „USB" button
3. Carrying handle
4. Display
5. LEDs
6. Light button
7. „220V" button
8. USB port
9. „-" button
10. „+" button
11. „MENU" button
12. 12 V car socket
13. „JUMP START" dial
14. Storage compartment
15. Compressor On/Off switch
16. Charging LED, green
17. Mains socket
18. 230 V socket
19. Fuse
20. Red cable with clamp (+)
21. Black cable with clamp (-)
22. High-pressure hose
23. Valve quick coupling
24. Valve for inflatable toys
25. Valve for inflatable toys
26. Valve for sports balls
Power Jumpstarter PJ125
EN
19