Tabla de contenido
Publicidad
G COPYING HOURLY PROGRAMMING
To speed up programming, you can "paste" the settings for a specific day onto another day.
Press V to select the day from which you wish to copy the settings.
Press the Copy key within 5 seconds to copy and then press the + and – keys to select the page onto which
you intend to "paste" them (the "destination" day is indicated by a flashing
Press P to paste and memorise the settings or V to cancel.
G TEMPORARY TEMPERATURE VARIATION
It is possible to vary set room temperature during automatic temperature control mode by acting on the +
and – keys. Variations will be shown on the display.
When this function is used the symbol indicating the present level goes out and the indicator light corresponding
to the relevant time slot starts flashing.
The new temperature will remain operative until the next value change, after which the programme will revert
to normal settings.
NOTE: Immediately after setting the date and the day (section 2) a factory-set default programme is activated.
This programme is given in the table below.
Low temp.
Comfort temp.
Low temp.
Comfort temp.
"MANUAL" TEMPERATURE CONTROL MODE
Pressing the
key enables manual operation of temperature control.
When manual mode is selected the
This mode excludes the daily/weekly timer and adjusts rooms temperature according to a standardised tem-
perature setting (modified by pressing + or -).
Standard Programme
from Monday to Friday
23:00+06:00
06:00+09:00
09:00+17:00
17:00+23:00
symbol appears on the display.
indicator).
Saturday and Sunday
23:00+08:00
08:00+23:00
50
Publicidad
Capítulos
Tabla de contenido
