Rampage TrailGuard Instrucciones De Instalación página 4

Installation Steps
Locate white wire with grey strip (power) and black
wire (ground), as shown in the picture.
12
Push light wires into the blue connectors.
14
Use pliers to squeeze the metal blade down enough
for the wires to push into the blade slots. Close the
lid and tug on the wires to confirm they are secured.
Test the lights.
16
NOTE: Actual application may vary slightly from illustrations.
Route license plate light wires under Jeep and back through
Twist two LED light wires together (black-black & red-red).
13
Slide the black wire (ground) from the wire harness
into the open channel of the blue connector with
the back wire, and make sure the wire is pushed all
15
Repeat steps 15-16 to install the other connector
(red wires).
17
Page 4 of 5
taillight opening.
the way in the slot.