Publicidad
STEP 11
Drive (2) M6 screws into only
the top (2) pilot holes (See
Fig. 10A). Position the door
so the screws fit into the
T-Type door mount bracket
(See Figure 10B). Making sure
the door is oriented correctly,
and using (2) #8 1/2" wood
screws, fasten the bottom door
mount bracket to the door and
tighten top screws (See Fig.
10C).
#2
STEP 12
Make the final door
adjustments. By tightening
the front screw and loosening
the back screw, the door will
tilt left. By loosening the front
screw and tightening the back
screw, the door will tilt right.
Once the door is adjusted
correctly, tighten the center
screw both on top and bottom.
Now snap on the logo cap to
cover this hardware (See Fig.
11).
STEP 13
The next adjustment is the left
and right position of the door.
Loosen the (2) indicated screws
on each T-Type door bracket.
Slide the door left to right so
that the overlay is the same
on both sides. Tighten both
screws on each bracket. Once
this adjustment is final, use (2)
#8 1" wood screws to lock the
door in place (See Fig 12).
6
FIGURE 10A
FIGURE 12
Customer Service: 800-626-1126 | rev-a-shelf.com
FIGURE 10B
FIGURE 11
FIGURE 10C
Publicidad
