Publicidad
STEP 14
The final adjustment is top to
bottom tilt. Loosen the (2) M6
screws. Using the 4mm Allen
wrench, tighten the front screw
and loosen the back screw to
tilt the top of the door out.
For the top of the door to tilt
in towards the cabinet, loosen
the front screw and tighten
the back screw. To adjust the
whole door downward, tighten
both screws the same amount.
Finish by tightening the (2) M6
screws (See Fig 13).
STEP 15
Attach the remaining door
mount bracket(s) (See Fig 14A).
The pilot holes drilled in step
10 should align. Figure 14B is
for 4" wide units only.
NOTE: Invert U bracket to
lock the door into place.
#2
STEP 16
Install the top basket clip first.
Position the basket clip inside
the frame and hold it to the
top. Snap the basket clips onto
the frame (See Fig 15). Slide
the basket down on the clips.
Confirm the desired spacing
between the baskets and
repeat for all remaining clips
and baskets.
INSTALLATION INSTRUCTIONS: 5300/5700 SERIES PULLOUT PANTRY
FIGURE 13
FIGURE 14A
FIGURE 14B
FIGURE 15
* 4" wide units only
7
Publicidad
