SICK GSE2 Flat Side Instrucciones De Operación página 9

8023329.18HX | SICK
Subject to change without notice
Observe the application conditions: Adjust the distance between the sender and the
receiver according to the corresponding diagram [see
ating reserve).
If several through-beam photoelectric sensors which are installed next to one another are
to be used, we recommend swapping the sender/receiver arrangement at every second
through-beam photoelectric sensor and ensuring that there is sufficient distance between
the through-beam photoelectric sensors. By doing this, mutual interference can be pre‐
vented [see figure 1].
Operating reserve
100
10
1
20 40
0
(0.79) (1.57)
Distance in mm (inch)
Figure 3: Operating reserve 50 mm
Operating reserve
100
10
1
0 40 80 120
(1.57) (3.15) (4.72)
Distance in mm (inch)
Figure 5: Operating reserve 150 mm
Operating reserve
100
10
1
0 200 400
(7.87) (15.75) (23.62)
Distance in mm (inch)
Figure 7: Operating reserve 500 mm
figure
1
0
0
60 80
(2.36) (3.15)
Sensing range
Figure 4: Sensing range 50 mm
1
0
0
160 200
(6.3) (7.87)
Sensing range
Figure 6: Sensing range 150 mm
1
0
0
600 800
(31.5)
Sensing range
Figure 8: Sensing range 500 mm
COMMISSIONING
3] (x = sensing range, y = oper‐
40 60
20 40 60
(0.79) (1.57) (2.36)
Distance in mm (inch)
Sensing range max.
150 200
40 80 120 160 200
(1.57) (3.15) (4.72) (6.3) (7.87)
Distance in mm (inch)
Sensing range max.
500 700
200 400 600
(7.87) (15.75) (23.62)
Distance in mm (inch)
Sensing range max.
7
80
(3.15)
800
(31.5)
9