Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Assemble a wire seal onto a wire.
2.
Taking care not to cut or nick the wire strands, strip 1/8" of insulation from
one end of the wire.
3.
Position the wire seal and wire into the terminal receptacle.
4.
Crimp the terminal receptacle onto the wire seal and wire
5.
Position the crimped wire/terminal receptacle into the appropriate plug
housing location and lock it into place.
6.
Repeat for other wire.
7.
Position the dummy seal plugs into the unused plug housing locations.
8.
Push the red end of the connector down until it locks into place.
9.
The connector is now ready for use.
B.
The LED Modules are designed to operate at 11-16 VDC and are designed to work
with Federal Signal flashers. Refer to the particular flasher instructions for proper wiring.
C.
To complete the installation, return to Paragraph IV. A. or IV.B. as required.
VI.
MAINTENANCE.
A.
General.
Crazing (cracking) of lenses will cause reduced effectiveness of the light. Do not
use cleaning agents (which will cause crazing) such as strong detergents, solvents,
or petroleum products. If crazing of lenses does occur, reliability of light for
emergency signaling purposes may be reduced until lenses are replaced.
Ordinary cleaning of the plastic lenses can be accomplished by using mild soap and a
soft rag. Should fine scratches or haze appear on a lens, they can ordinarily be removed with
non-abrasive, high quality, one-step, automotive paste cleaner/wax and a soft cloth.
B.
MODLED1F , MODLED2F, and MODLED3F LED Module Replacement.
1.
Remove four #10 x 3/4" mounting screws from the LED module/bezel
assembly.
2.
Disconnect the wiring connector.
3.
Place the LED module/bezel face down on a flat surface, being careful not
scratch the LED module lens(es).
4.
Remove the three #8 x 1/2" screws which hold the module in place.
5.
Pull the snap tabs, which hold the module in position, away from the module.
The module should fall away from the bezel.
6.
Place the module/bezel assembly lens side up and position the new module in
place, until the snap tabs hold the module assembly.
7.
Install the previously removed screws and wiring connector.
WARNING
-4-
Publicidad
