Note: Inappropriate selection of disinfectant solution may result in damage to unit including corrosion, pump failure, reduction
in mist performance etc. The NSU is fully compatible with disinfection solutions based on Quaternary Ammonium Salts or
Hypochlorous Acid using appropriate dilution levels. Use of other chemical / disinfectant solutions may invalidate warranty.
Never spray into or towards faces.
WARNING IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do.
Continue rinsing. If eye irritation persists: Get medical advice/attention. If medical advice is needed, have product container
or label at hand.
Always refer to the MSDS (manufacturer's safety data sheet) for safe usage and disposal.
Only use the chemicals / detergent solution provided. Replacements available from Numatic.
TECcare CONTROL Concentrate.
Hazards Identification
P264: Wash hands thoroughly after handling
! !
P280: Wear protective gloves/eye protection
P305+351+338: IF IN EYES: Rinse cautiously with water for
several minutes. Remove contact lenses, if present and easy
to do.
Continue rinsing.
P302+352: IF ON SKIN: Wash with plenty of water.
P304+340: IF INHALED: Remove person to fresh air and keep comfortable for
breathing.
P312: Call a doctor if you feel unwell.
This chemical should be kept in the packaging/container provided, as other
containers might not provide the required protection and preservation of the
chemical.
Environmental precautions: Do not discharge in to drains or rivers.
TECcare CONTROL Concentrate Hazardous ingredients:
DIDECYLDIMETHYLAMMONIUM CHLORIDE
EINECS
CAS
230-525-2
7173-51-5
ALKYL DIMETHYL BENZYL AMMONIUM CHLORIDE
EINECS
CAS
270-325-2
68424-85-1
CHIP Classification
Xn: R22; C: R34
CHIP Classification
Xn: R21/22; C:
R34; N: R50
CLP Classification
Acute Tox. 4: H302; Skin Corr. 1B: H314 H314
CLP Classification
Acute Tox. 4: H302; Skin Corr. 1B:
H314; Aquatic Acute 1: H400
Chemical Information
Percent
<4.5 %
Percent
<2.5 %