Troubleshooting & Faq - Impossible I-1 Manual Del Usuario

TROUBLESHOOTING & F.A.Q.
The I-1 won't eject Make sure that the control knob is in the 'on' posi-
my photo tion: the yellow line on the control knob should be
lined up with the line on the shutter button.
Make sure that your I-1 camera is charged: the
power indicator LED should glow red if the camera
is on and charged. It will rapidly blink red if it
doesn't have enough power to operate. If the light
doesn't turn on, the battery may be completely
empty and need to be charged.
Make sure you still have fi lm in your camera: to
check, turn the control knob off and on. The ring
fl ash will indicate how many shots you have left.
If the red LED (top) in the ring fl ash blinks rapidly
when the camera turns on again, this means that
there are no shots left in the fi lm pack, or that no
fi lm pack is inserted.
Make sure you press the shutter button all the way
in to ensure that the photo ejects properly. If the
camera is still unresponsive, try pressing the reset
button inside the fi lm door to do a hard reset.
The ring fl ash
Make sure that the ring fl ash is switched on – the
doesn't fi re when I fl ash on/off switch should be pushed up so it meets
take a photo the yellow lightning fl ash symbol.
18 | English
(continued) If the fl ash still won't fi re, then the camera may be
conserving battery life in low power mode. You can
check if this is the case by looking at the red power
indicator LED – if the camera is on and it is blink-
ing, the fl ash will be inhibited in order to conserve
battery, and the camera needs to be charged.
My photo turned Make sure you use the camera with fl ash ON: we
out slightly
strongly recommend that you always use the fl ash
too dark when shooting indoors, as well as outside at night-
time, at dusk and on cloudy days.
Make sure you are not shooting towards the sun:
the I-1 meters the average light level it sees. When
shooting towards sunlight, the sun exposes the
image in such a way that it can become too dark to
reveal your subject properly.
Move the lighten/darken switch
side of the lens barrel to the + position for a
brighter image.
on the right
C
English | 19