SAFETY INFORMATION
CAUTION – RISK OF ELECTRIC SHOCK – DO NOT
OPEN/DISASSEMBLE THE MOTORIZED ROLLER
SYSTEM.
· Do not disassemble the device. Incorrect reassembly
can cause electrical shock if the device is used again.
· Do not immerse the device in water or other fl uids.
· Do not operate the device in a high humidity environ-
ment or very dusty environments.
· Do not attempt to tamper with, adjust or remove the
battery and/or the electronics located below the rollers
behind the device's fi lm door.
· Do not attempt to remove the door itself as it is
connected electronically to the body of the device.
Doing so is unsafe, will likely damage your device, and
will void your warranty.
· Do not insert metal objects into the product.
· Do not insert any objects into the rollers or gears.
· Keep small children and infants away from the
device to avoid them being injured by the device's
moving parts.
· Do not use or store the product near any heat source
or any type of equipment that generates heat, includ-
ing stereo amplifi ers.
· Do not use the device near fl ammable or explosive
gases.
· Do not charge the device if you notice any unusual
odors, noise or smoke.
· Do not attempt to disassemble the fi lm's battery or
modify it in any way (if using 600-type fi lm). If battery
fl uid gets into your eyes, immediately rinse your
eyes with fresh cold running water and seek medical
attention immediately.
BATTERY AND CHARGER
· This device uses a custom Impossible lithium ion
battery that is non-removable and mounted inside the
camera body. No other type of battery can be used.
Battery replacement can only be done by Impossible
Service Centers. The battery will provide many years of
24 | English
service if properly used.
· Power consumption varies depending on the
environment the device is used in and how the device
has been stored. Used directly after full charge, the
battery will power the processing of up to 20 fi lm
packs with fl ash exposures. Due to the high energy
requirements of the fl ash, we recommend charging the
camera before every session for best results.
· Once the battery energy level falls below a certain
level, the device will no longer process fi lm. The LED
will blink and signal when it needs to be recharged.
This is to avoid a photo getting stuck as it's being
processed through the roller system.
· The rechargeable battery is not fully charged at the
time of purchase. Charge the battery fully with the
Impossible USB charger (provided). This usually takes
1-2 hours (can vary depending on usage).
· The supplied battery charger has been tested and
certifi ed to work with the Apple iPhone power adaptor.
While it can be used in other USB ports, e.g. comput-
ers, USB power adaptors, TVs, cars etc., Impossible
cannot guarantee correct operation.
· When the device is no longer in use, please recycle
it properly.
USAGE ENVIRONMENT
· To protect the high-precision technology contained in
this device, never leave the camera in the following
environments for an extended period of time: high
temperature (+40°C/104°F), high humidity, places
with extreme changes in temperature (hot and cold),
direct sunlight, sandy or dusty environments such
as beaches, damp places, or places with strong
vibrations.
· Do not drop the device or subject it to severe shocks
or vibrations.
· Do not push, pull or press on the lens.
COMPLIANCE
Important directions for using Lithium-Ion-Batteries
1. Do not throw into fi re.
2. Do not short circuit.
3. Do not disassemble.
4. Do not continue to use when damaged.
5. Dispose correctly.
EU DECLARATION OF CONFORMITY
Hereby, Impossible B.V. declares that the Impossible
I-1 Analog Instant Camera is in compliance with the
appropriate essential requirements of Article 3 of the
R&TTE and other relevant provisions, when used for
its intended purpose.
FCC
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Caution: The user is cautioned that changes or
modifi cations not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment
and receiver.
· Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
· Consult the dealer or an experienced radio/TV
technician for help.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. End
user must follow the specifi c operating instructions
for satisfying RF exposure compliance. This transmit-
ter must not be co-located or operating in conjunction
with any other antenna or transmitter.
INDUSTRY CANADA (IC)
This device complies with part 15 of the FCC Rules
and Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux condi-
tions suivantes : (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre
le fonctionnement.
SOUTH KOREA
해당 무선 설비는 운용 중 전파혼신 가능성이 있음
TAIWAN
本產品符合低功率電波輻射性電機管理辦法 第十二條、
第十四條等條文規定
1. 經型式認證合格之低功率射頻電機,非經許可,公
司、商號或使用者均不得擅自變更頻率、加大功率或變
更原設計之特性及功能。
2. 低功率射頻電機之使用不得影響飛航安全及干擾合法
通信;經發現有干擾現象時,應立即停用,並改善至無
干擾時方得繼續使用。
前項合法通信,指依電信法規定作業之無線電通信。
低功率射頻電機須忍受合法通信或工業、科學及醫療用
電波輻射性電機設備之干擾。
English | 25