Festo SFC−LACI IO Serie Manual De Instrucciones página 15

1 User
Intended use
The SFC−LACI is used as a position controller and position
controller for DNCE− −LAS and DFME− −LAS type drives
The master controller (PLC/IPC) is connected via the con
troller interface:
SFC−LACI−...−IO:
SFC−LACI−...−PB:
SFC−LACI−...−CO:
SFC−LACI−...−DN:
Commissioning and parameterisation are carried out:
with the FCT software package and the SFC−LAC
plug−in (from V.3.0.0 and higher) via the RS232 inter
face or
for type SFC−LACI−...−H2 optionally with the control
panel (display and four operating buttons).
Note
This brief overview serves only as initial information
and does not replace the complete documentation,
which is contained as a PDF file on the CD ROM sup
plied.
S You must observe the information and the safety
instructions in the complete manual for the motor
controller.
S Please consult your local Festo Service or write to the
following e−mail address if you have any technical
problems: service_international@festo.com
Festo GDSP−SFC−LACI−ML 0812NH English
instructionsEnglish
Digital inputs/outputs
PROFIBUS−DP
CANopen
DeviceNet
15